Hello everyone,
In a sketch, I'm looking for the function to create a tangent ray, with minimal manipulation.
In the example, it is the R7 radius in question.
Thank you
capture_decran_2022-10-06_095143.jpg
capture_decran_2022-10-06_095143.jpg
Hello
For you, what is a minimum of manipulation?
Or in sketch mode, draw a straight line, pretend to draw a straight line and hold down the left click and hover the mouse pointer over the point and then go to the desired side so that it directly draws a tangent arc (see attached video).
sldworks_ywpbuydmhp.gif
7 Likes
Thank you for your answers,
I may have expressed myself badly; I want to make a tangent arc between 2 curves, with a function.
Thank you
Re Mmi,
Precisely, the Arc Tangent function allows you to do this, right?
If not, I still don't understand your request^^
Nicholas
2 Likes
Hello
If you want to use a function like leave it's possible but with restrictions.
Both curves must be open. The two (straight) curves must intersect and extend them.
There is no other function besides the arches.
There are not 36 solutions for a minimum of manipulations. There is only one.
Choose " arc by 3 points ", click a 1st point close to one of the entities,
then a 2nd point close to the other entity, then go and place " the middle point" roughly
between the 2 entities. Next, force a constraint of Tgt between the arc and each of the features
and indicate a radius. So there are 7 manipulations. That's the minimum.
