Hello
I obtained a result of a first simulation of a cork under a pressure of 0.18 N/mm^2. See the screenshot.
Starting from an assembly of the two parts or by staying only on the cap, I would like to use a design optimization with Max deformation criteria as on this demonstration
https://www.youtube.com/watch?v=pCGzC13YOGc&ab_channel=VisiativSolutions-SOLIDWORKSCATIA3DEXPERIENCE
I will already be very happy to have variants on the model with wall thickness dimensions, or an optimization of the mass.
Obtain a variation of the cap design.
The basic model is a graphical block, the function dimensions do not appear and features expert does not give all the parameters.
I can by conversion of the entities find the 3D sketches and go back to the surface to sew all the surfaces, it's long, I finished the external part with the original grip;
The thread part is a standard, it is also possible. How to feed a graphic block model with dimensional criteria, in import I checked Surface model, the entities are active.
The last point is a test protocol, the pressure must be of the imposed value for 30 min and measure the residual plastic deformation.
Step done in the workshop, and then pouring resin without pressure to fill the deformation, the part obtained a master's degree is measurable.
To present a pre-design, we would like to go through digital modules before moving on to a physical 3D printing mold.
The problem is to also do a fatigue study but without a variation curve, to have a constant of the pressure, can we define a load without going through cycles?
This is different from static loading, over a time and not over a longer range............ How to proceed?
Thank you for your help.
Spectrum.
