Hello
I'm looking to fill with material between the underside of the helical slope and the lower plane (material represented in red thanks to my talents on paint), do you have a tip the community?
I tried to fill in the material and then do a combined function but I didn't get the expected result.
Thank you in advance
Hello
A simple projection of the sketch on the plane and extrusion to the body?
If not, surface and make it a volume to combine.
I hadn't thought about it... I started a sweep with a propeller in the opposite direction and then a combine function, but it requires more function than with your proposal! Sometimes, we want to make it complicated when there are simpler things! Thank you Cyril
Hello
Create the thicker helical section, and I would have created the flange after.
Sir
My name is Liu-Dai Eva, a GMP student at the IUT gratte-ciel in Villeurbanne. I would like to take the liberty of contacting you with my comrades Lo Pizzo Vincent and Savinel Dejan.
As part of our training, we must forge our further study in particular through our personalized professional project but also by learning about different technical professions. This is why we want to discover the job of senior technician in a design office
Thus, we would like to know if it would be possible to give us about thirty minutes for an interview about your job and more precisely its objectives and missions.
While waiting for your reply, we ask you to accept, Sir, the expression of our best wishes.
Kind regards
LIU–DAI Eva
