Hello, I have a question about the k-factor after doing sheet metal function recognition on an imported part.
The K factor does not seem to have an influence on the dimension of the unfolded, is this normal or did I make a wrong handling?
I'm on version 2017 SP3.
Thank you for your answers.
gt22
2
If you change the K factor
You also need to Delete the old Unfold
and make another one
made a record before
And after modification
and control the diff
@+
When you mean delete the old unfold: is it to put it in a state of deletion or to delete it completely (I don't know if that's possible)?
It depends if you change the bending radii because otherwise it won't change much.
2 Likes
g
5
Hello, if you have several folds, be careful to modify the general K factor and not that of one of the folds!
Kind regards.
1 Like
I have a tutorial that explains how to change the bending radii of an imported part.
1 Like
"It depends if you change the bending radii because otherwise it won't change much."
When I create a sheet metal part, the dimension of the unfolded changes as I change the coeff of the K factor.
I modify the K-factor of the sheet metal function and I check that the ply functions follow the parameters.
"I have a tutorial that explains how to change the bending radii of an imported part. "
Thank you very much your solution allows me to modify the rating according to the K factor.