Hello
I work on the underside of a boat,
I would like to know if there is a way,
to have a degressive angle with this function??
a wide angle at the level of the V and an increasingly
optu by going towards the nose of the carenne. Currently
the angle is constant.
(see photo of what I would like)
A big thank you to whoever will have the solution.
Don't hesitate to use guide curves.
Your link gives me a hieroglyph page that I can't seem to use.
Yes it must be on my side, I have the impression that when I copy the text, it doesn't stick the same thing to me.
As we exchanged by email, I sent the file back to you. I started from scratch by starting with the surface.
I hope this helps you.
Many thanks to Freeman_83 ui helped me take a big step
towards the desired result.
Apparently you would have to work on the surface, and I don't know anything about it,
I therefore put the result obtained by Freeman_83 for those who wish to bring
a contribution to my project.
Thank you.
I'm not a surface pro so be indulgent about my method.
It gave me at least one exercise.
Hello
No solidworks available so impossible to open the files.
However, to have variable cross-sections, it seems to me that you have to use the smoothing function with guide curves and not sweeping.
For this type of geometry, going through surface area first also seems preferable rather than attacking directly on volume.
Hello
I would need a helping hand in surface I think,
to make this piece, I don't solve the necessary method,
so that the nose, is an edge on the width.