Hello
When I start my simulation, it says: Mesh generation interrupted. Whereas without touching the mesh, the simulation before did not have this problem. Does anyone know how to fix it?
Thanks in advance!
Hello @ flefustec"
With so little information, it's hard to tell you something.
The first thing to check is the size of the mesh. Failures are very often due to a mesh that is too coarse.
It is better to use the mesh detail for the configuration. This allows you to better define the max mesh but especially the Min value which is very often the big fault in the corners, edges etc...
Then, depending on the look of the piece, there are more subtle ways to make the mesh go through.
Can you post an image of your room with your mesh settings, it will give us an idea.
Kind regards
Hello
Thank you for the answer. My problem was solved as it came. I just saved a copy of my model and ran the calculation again. And no more problems.
Good evening
Happy for you that you were able to solve your PB very easily.
I'm not surprised by what you describe, it happened to me once or twice. It is the work of the devil of pipes. ;-)
Kind regards