Hello
Impossible to select a sketch entity, it systematically selects its dimension.
Even if I select the selection button in the filter bar, it always brings me back to its rating
Does it have a keyboard shortcut to impose the selection filter???
Is it also possible to reduce the size of the dimensions and their arrows???
Thank you in advance for your help
Hello
I would have said that there is a filter problem but obviously you have already tested.
As for the size of the arrows, just go to options/ document properties/ dimensions, there you can change the text sizes and arrows.
By right-clicking/"select others"?
It may not be impossible that your dimension line overlaps the sketch line also in this case move the dimension or its attachment points.... to be seen.
Hello
Pay attention that there is only one asset filter.
To show and hide the filter bar , the default shortcut is F5
F6 to disable the selection of current filters
In SW2017, you can add a configurable shortcut for vertice, face and edge filters
As FUZ3D says , the arrow size is set in options/ document properties/ dimensions
To save my changes, I create a dressing standard.
To Stefbeno I didn't select other in the right click.
A fuz3D ok it's good
On the other hand, when I print my sketch screen, I don't have the measurements of the dimensions that are spicy, just the arrows delimiting the dimensions