Hi all
I would like to know if there was a trick/function to prohibit values (intervals) of distances between two components (angular or linear).
Example: a mechanical stroke between two parts that must be between 150mm and 450mm - the goal is to enter a fixed value (and not free like the free slide constraint) but that it warns or prohibits the value entered outside the interval.
I tried to apply Excel functions in " Equation " but without result.
Thank you.
It is possible to define a sensor that will check if the length is between the defined values and if it is not it displays an error. (No prohibition)
Hello
Thank you for this feedback,
I'll try to apply this solution,
Is it possible to create a physical alert (e.g. pop-up)?
Hello
It's ' limit distance' in linear: you set a dimension between two limit values (with SW warning if you want to exceed the limits of the limits)
Possible that there is the equivalent in angular.
Hello
For the angles it's the same but instead of putting a distance value (in red below) you have to put an angle value (in green below). The boundaries are in the 2 cases to be put in the fields circled in blue below.
