Tie Line, Break Line PDF Problem and Printing

2D plans Layout
1

Hi all 

Here I have a small problem with the display of breaklines:

As above, you can see that I have enabled the break line of the dimension, but when I switch my drawing to PDF

or in direct printing this line break disappears: 

Any idea if it's a bug or just a setting to activate, thanks in advance:)

 

 

 

 

2

Up:/

 

3

Hello

Does moving the odds cause the break to reappear?

When printing, SW reconstructs the drawing, occasionally causing small shifts in the dimensions and as a result the break lines in the dimensions can disappear. The important thing is, does it come out well in print (PDF or direct print)?

If so, it's just a display bug. I find that these breaks are quite unstable in use (SW2016 SP5).

 

4

2Hello, Thank you for your answer, 

Regarding the two photos I put above the first one is on SolidWorks, when I move the dimension in SolidWorks the break line follows very well, but the second image is on a PDF, as soon as I print (Preview or print) or I change it to PDF this break line disappears. (SW2018 SP2)

 

5

Oops badly seen that it was the PDF, I just looked on my SW2018 SP2 workstation and not the problem.

We should see with the support if they have an idea where the problem comes from because there is no specific option to my knowledge.

6

Okay so it's likely that I changed a setting, which could explain why it doesn't appear on my PDFs. 

Thank you.  :)

 

7

Hello

Try to update to the sp3 that has just been released. The bug may be fixed.