Bending Line

In multibody parts generally... but in assembly it also happens to me!!

but here in this case it's in multibody where I have this problem ... So I'm going to create the independent parts and insert them into an assembly because I'm not going to linger on this trifle that melts me waste a little too much time ...  

 

I very rarely work in multi-body because more problems than in single parts. Most often I start in an empty assembly and create my parts in it as I go along, the principle is identical to the multi-body but with the disadvantages minus.

Okay I'm going to review my way of working and you're not the first to tell me since the beginning of my research. Thank you very much for taking the time to answer me and I will keep you informed if in assembly mode its solved my problem.

No worries, normally it should work better.

Back to the subject...

Starting with an empty assembly and creating the parts as you go is the best!! Thank you for everything ac cobra 427.. The pleasure of drawing comes back to me!!

1 Like

Aren't the bending lines on the opposite side of the sheet metal? In this case, changing the fixed face could reveal the folded lines that are not visible on the outside side?

I'm afraid to say something stupid, but you never know ^^

 

This is a bit like the problem I had, no engraving strokes when exporting in dxf... They were on the wrong side

1 Like