Hello
I have a problem in a lot of my drawings, on sheet metal parts I often have the problem that my bend lines become grayed out on their own when reopening the drawing file. I am then forced to delete the unfolded state configuration, and to redo it to get these lines again in the MEP....
Thank you!
Hello
The same problem here and no solution:
https://forum.solidworks.com/thread/90479
Hello
Do you have a screen shot? greyed outs?
All my other parts are in color (configured in the document options), and this one is not. I have already had this problem on other folded parts....
They should appear in red, right? instead of grey.
Basically, the layer of the bend lines jumps. Is that right?
I open the model, I click on "Unfolded" of the command manager (to deactivate the unfolded) I click again (to do it again...) and miraculously the colored lines are back ?...
I don't have a special layer, I use Document Properties > Sheet Metal
Thank you
Ok, in the document properties, in the sheet metal tab, the bend lines up and down etc... have a specific color (in your case, red)
Yes it's already defined for the whole document, when I do it at the moment it works, it's when I close Solidworks and open the plan again that the range lines become grayed out (and by the way the small "folding note" box also on the left in the menu)...
Then I open the room, I press "Unfolded" 2 times and it's OK it comes back normal...
In this case, if it really turns out to be a bug, I advise you to go through a macro to do this operation much faster in one click.
Reconstruction doesn't work?
Can you send me the part in question?
> Not Walk with Rebuild
>My solution doesn't make it possible to edit the folding notes unfortunately...
>I have the problem on quite varied parts, so a macro I don't really know.
Thank you
Ba for macro, it's not very complicated.
You record a macro with the operations you usually do.
When you have put your new unfolded view back you stop the macro and save it with a button in your menu at the top.
So you open your plan, you click on the button of your macro, your unfolded view is blocked, the new one is inserted and unfolded.
Wouldn't that be okay?
Of course it's always better when it doesn't bug^^
For the macro, I do the test when I get home and send you a video if it works;)
It works, thank you!