Hello everyone, I would like to limit openings in a room by a trajectory,
Apparently, its not working in my case why? I'm putting screenshots plus the room for more information thank you for your answers.
Marco.
Repeat-2 test. SLDPRT (100.9 KB)
Repeat-2 test. SLDPRT (100.9 KB)
Hello marc_malavielle,
I just found this, maybe it can help.
=>https://help.solidworks.com/2016/french/SolidWorks/sldworks/t_Vary_Sketch.htm?id=20.5.27.0.2
For my part, I think you have to close your outline of trajectory.
On SW 2022 SP4, it is possible to do this on a Zone.
… To be seen.
@+.
AR.
Hello;
You have to position your material removal sketch at the junction of your two trajectories (or rather on the bisector of the triangle).
Then decompose the linear pattern into 1 Vertical pattern with the direction of the distance dimension to be respected (Minimum distance between the cut and the edge of the solid).
And a horizontal trajectory with the other dimension mini as the reference.
Note: the two trajectories traced at 10mm are no longer necessary...
If you are satisfied with the result geometrically, all you have to do is click on " Vary the sketch ".
Note: Thank you for the reminder that this function exists, I had completely forgotten 
about it 
Attachment: Solidworks 2022Sp4.0
Variable repetition by trajectories. SLDPRT (174.8 KB)
Hello @marc_malavieille ,
A priori, checking the " Piloting " box in the trajectory properties gives the expected result.
With 12 occurrences in the repeat, the plate is completely swept away by the openings.
1 Like