Hello everyone,
I'd like to know how to apply imposed displacements to a machine that is just placed on the ground (and not spited).
With a flat support, the machine moves 200mm on one side, which is absolutely impossible in reality...
Thank you very much!
You can just fix a point on a frame.
It should stabilize your model
Hello
There is an option for these cases, the low stiffness available by right-clicking, property on your study
Copy of acran attached
A+
Mick
@Mick therefore with no imposed displacement?
Yes, or you can leave the plane support, I think, at mons, you block on Y
I'm going to try but I'm afraid there will be an impact on the simulation.