Hi all
I am facing a problem for which I have not found the answer on the internet, I want to mesh a sheet metal part, it is not a problem, however several leaves disappear and this causes holes in my mesh model. The problem comes from the dividing lines that I drew since by removing them the mesh is correct. But I absolutely need it to apply my strength. Anyone have an idea?
Thank you
Hello
I guess it's a static simulation!
The first thing to do is to refine your mesh and also reduce the mesh locally through local mesh control.
But there are so many possibilities (especially in the global settings because you have several volumes apparently) that it's hard to say more without seeing the model. In particular, how are the dividing lines made. (which I also often use to apply local forces)
Can you post your piece if you are not in SW twenty twenty I only have the SW 2019.
Kind regards
Thank you for your answer,
I finally solved the problem by modifying my separation lines, they are less representative of reality, but still satisfying