Hello
I want to transform it into a welded mechanic from the volume part.
So far so good.
On the other hand, this mechanically welded part does not suit me because it is difficult to bend.
I therefore want to transform this volume into two mechanically welded pieces that will be welded together afterwards.
For the moment the only solution I have found is to start from the volume to separate them before working them individually in sheet metal.
It would be faster to cut the part after a "shell" function and sheet metal
I have tested the "cut" function, unfortunately it does not allow you to separate the volume entirely in two or to make a cut with partial overlap to fill with weld.
Do you have any solutions?
Thank you
Julian