Hello
When running a simulation calculation, the following message appears:
"The intermediate layers are not defined at the level of the countersink bolt type connector with 6-nut"
Attached is a screenshot of my set. It is a three-piece "shell"
Thanking you in advance,
Kind regards
Hello
Small remark :: If I see correctly on your picture there is still a bolt but the "bolt connectors" are intended to replace the physical bolts. It also assumes that all the contacts between components have been correctly defined.
In the absence of other information, it is difficult to say more because there are only 6 parameters to enter for bolts. In addition, not all your holes seem to have been set up. We also don't see the solder or spot solder connectors.
Kind regards
Hello
Thank you for your feedback. The indication of the intermediate elements between the part receiving the head and the part receiving the nut was missing. The screw through-area must be indicated.
Kind regards