Hello
I want to put an internal reference as a bubble of the planes, so far so good with custom properties. The problem is that when I associate the snap lines with the underscore of the property, the vertical minimum space is equal to the maximum horizontal space. (see image), it is not possible to condense them!! While it works very well with the property framed!
I don't even think there's a solution to my problem.
Thank you for your remarks, if there are any.
Hello
It also doesn't work by shortening the magnetic line?
Kind regards.
Hello
It is precisely by shortening the line all the way that the vertical spacing is still equal to the horizontal spacing. My property has 11 characters, so the minimum vertical spacing is 11 characters, whereas it should only be in line spacing.
Thank you for your questions and comments.
Hello, what do you have in the properties of the property???
See attached file thank you
It is possible that Solid keeps a circle of outline in memory and therefore keeps a minimum space between the numbers.
G.
Hello
Here's what I have in the property manager. My problem is that vertically when you select "underlined" the minimum vertical spacing is equal to the horizontal spacing either "at best" or "User defined = 30 mm" while it works very well if you don't underline the property or the number.
Otherwise you can click on the magnetic line and, in the property manager, change it to "free position".
Yes, but it doesn't change anything...
Hi, when you configure your dressing standard you have to change the value on the attached capture.
Kind regards
Maybe you'll have better luck with this new catch... :)
Hello, a possible variant to get around the problem, is not to put a magnetic line, arrange the bubbles more or less and then select them all, align them and distribute them evenly vertically.
Kind regards;
G.
I think this utility would do the trick
SmartBalloons
http://www.mycadblog.fr/wp-content/uploads/2016/02/Pr%C3%A9sentation-des-utilitaires-2016.pdf
@+ ;-)
Hello
Thank you for your answers but:
-The capture to underline corresponds to the properties of the notes and not the balloons
-I would still like to use the magnetic lines which are very useful for large sets and especially when adding bubbles
-With Smartballoons, it is not possible to emphasize (see image)
I really believe that there is no solution.......
Sorry
@+