Hello
I'm looking for how to change the path of the .prtprp property file because it puts it in the old 2012 folder for my solidworks 2013
capture_acces_prtprp.png
Hello
I'm looking for how to change the path of the .prtprp property file because it puts it in the old 2012 folder for my solidworks 2013
if you have watched the tutorials
http://www.lynkoa.com/tutos/3d/solidworks-le-formulaire-de-proprietes
http://www.lynkoa.com/tutos/3d/editeur-de-formulaire-solidworks
They talk about it and should not be stored in solidworks files
for the step lost them at the change of version
@ Gerald you didn't look and listen well ;-(
@+ ;-)
File Location option BOM template
When the first table is inserted, save the record path to a secure location
Above all, do not save in the default installation paths in Solidworks
If you uninstall solidworks you will lose everything (it's stupid)
Hovered the location of this corresponding document for this in the SOLIDWORKS options in File Locations Select the custom property file filter Delete the default path and then add it back to custom files You could only point to one path
from 25 mm of reading in the tutorial
http://www.lynkoa.com/tutos/3d/solidworks-le-formulaire-de-proprietes
@+ ;-)
Hello, you have to go to your options, then to file locations, then document templates.
You remove the template folder from the list, and you add the one you want.
See attached image
Hi gt22
I have seen listen to create text files and all the toutime. But I didn't see in the tutorials this very specific point of changing the repertoire. Because in the tutorials it creates and the file is placed but if it already exists it's not the same
My setup is so that all my document templates, solder profiles and everything else are on another hard disk.
It's only this property file created in 2012 that causes me problems
moreover I uninstalled 2012 but the folder is staying
I'll try to delete the folder
See my answer! ^^
View this image
SOLIDWORKS Option
File location
Filters Custom File Properties
Remove the default path
and add it later
file location only one path possible
@+ ;-)
@gt22
I'm almost 40 years old so the little writings if they don't read them to me I don't see them!!
;-))
and me 60 what should I say ;-)
@+ ;-)
in option/system option/file location/custom property files
then:
custom property file and SOLIDWORKS offers you a default path with templ/lang something like that
So you delete it because THERE CAN ONLY BE A SOURCE FILE FOR THE PERSONAL PROPERTIES
and you replace it with one of your custom files by creating a new path, which you choose elsewhere than in the default SOLIDWORKS location (otherwise your form templates will not be taken into account in future versions of SOLIDWORKS.
I learned everything with these lynkoa tutorials: here it is
http://www.youtube.com/watch?v=sueIfwDTW_Q
@Nicolas
it's Bart's answer in longer
the tutorials yes to create modify but the selection step in option like Bart's image it is not there
Precision if like me you have different versions (2013 and 2014 on the same workstation) make the changes with the oldest
instead of document template you have to click on
CUSTOM PROPERTY FILE
as an attachment below
And that's where you click on delete path and create another one that you save elsewhere than the default path of solidworks
@+