Hello.
I have a problem displaying the part name when I make a bill of materials.
Instead of telling me the name of my assembly (E600-000-005), it tells me " plastic cap"!
However, there is a link in the cell because when I go to the box, it asks me if I want to break the link.
How do I give it the right name with the associated link?
E600-003-002 droite.pdf scale (79.8 KB)
Is it an assembly with several parts?
Possibility to see the tree structure of your main assembly to compare to the nomenclature?
Do you have any configurations in your assembly or the name is not correct? (property related to the erroneous configuration for example)...
Many reasons can justify the error, it will take a little more information to understand.
No configuration, just an equation
Hello
Right-click on row 5 of the BOM table and open the part in SolidWorks.
Then you're going to see in the custom part properties and the configuration-specific properties, and you look to see if you find your "Part Number" line
Can you open your assembly E600-000-0005 and look in the property:
in 1st in the custom tab if a property exists with the plastic cap value
in the 2nd in the Configuration Specific tab, same value to look for.
If necessary, post the 2 screenshots.
hello CathyN,
(SW202SP4)
Try to check this too it can come from here =>
