xdmr33
May 12, 2014, 12:55pm
1
Hello, I have a problem on my sketch I need to take a leave and I don't understand why I can't select a line to make a leave with it. On my other sketches it works but here I don't understand.
Second small question is it possible to show or hide the dimensions on the sketch.
Thank you.
PS: I looked but didn't find it.
Hello
Could you enclose a screen print concerning the problem of leave?
Sometimes, it happens that the radius of fillet is greater than the length of the line and therefore the fillet is not made...
To hide the ribs, just right-click on it and then "hide"
EDIT: Don't p^report, I thought it was under SW and I apologize...
1 Like
bart
May 12, 2014, 2:33pm
3
As Jose says, you will need an attached file, (screen print or even the part itself)
try to reduce your bending radius
Well, the sketch worked before and now I don't know why it doesn't work anymore.
If I open the sketch to do a test for example: I link 2 lines that make a 90° angle, the fillet function does not select the lines.
It's the 1st time I've had a problem.
Apparently I'm going to redo everything on another sheet, that's the only thing that works but what a waste of time and fatigue ...
Thank you even for your help.
bart
May 12, 2014, 9:58pm
5
And a copy paste of your sketch into a new room???