Hello
Will anyone have a tip for a change of state stipulate when checking the material property that it is only for the parts, because I will encounter a problem when changing the state of the sets which have the empty property.
Thank you in advance
Hello
You have to go through the conditions in the tab of the same name in the transitions. By doing a check on the file type and the content of a variable it should meet the need.
I created a category sldasm, sldrw, then in or control either the material or the category which should result if it's a part I must have matter, the others it's not important.... but I remain a failure
Hello, The problem is solved by doubling the automatic transition step (in red).
one for 3D parts and the other where the conditions are for non-3D parts. I used a create category specifically for that