Hello
last night my station did a W10 update, and since when I want to launch SW, the following message is displayed:
I went to check the licenses in the Network license manager, the following message
and no license available...
So the BE is blocked, what can I do to solve this problem?
Kind regards
Michael.
gt22
September 30, 2016, 7:43am
2
From what I understood you need mini the sp 5 of 2015 to work with windaude 10
http://www.solidworks.fr/sw/support/SystemRequirements.html
gt22, we have been under W10 with SW2015SP5 since July and everything was going very well, until the automatic update on my station last night...
Have you attempted a Solidworks repair?
Otherwise a reinstall with SP5 this time (SP0 is still buggy)
PhilippeB, I'm already in SP5, apparently I should update the license manager, but the installation CD doesn't offer it to me
bart
September 30, 2016, 8:08am
6
And if you go to your Solidworks account on Solidworks.fr and click on "register a product" you enter your Sw key and see if the update is possible...
Hello
see if you have a restore point before this update, if so, restore the PC to this date and then you look for the said update and you block it so that it doesn't happen again.
1 Like