be2_21
1
Hello, I'm looking to export a set with a lot of parts, and I'm wasting a lot of time exporting each part of the set, one by one, in STEP
Is there a way to do this? And by going through a "pack and Go"? by the SW explorer ?
I'm in 2019 SW version
Best regards to all
2 Likes
Hello, yes with this macro
1- Open the assembly
2- Launch the macro
3- Show him where the file is with the parts and off you go.
but be careful it will do all the parts in step even if you have parts stored in the folder that are not in the 3D.
May the force be with you
step_en_masse.swp
3 Likes
Hello
There is a tool from the myCADtools suite (BatchConverter) that perfectly meets your request.
You can test this suite for 30 days by clicking on the "MYCADTOOLS Discover" link that you can find in the "My services" block of the home page.
Don't hesitate because there are probably many other tools that can be useful to you and save you time.
Kind regards
image.png