Hi all
I am addressing people making 2D plans, or implementation.
My problem: What is the representation to use when several pipes, or cable are in the same place and those over a long distance. Since we are seen from above, they are both on the same line...
Thank you!
it is the front view that of # the pipes or some cross-sectional views at the right of the change of sections
@+ ;-)
you can make interspers to see the pipe underneath with its label and name
Hello
Personally, in this config. Seen from above, I draw a single tube, but I put a text explaining the diameters in flag + addition of a detail section with supports....
Look at this link
http://fisarevitmep.wordpress.com/category/temoignages/
@+ ;-)
Information taken from a designer (BE Fluides) of what is most practiced in the building, there are 3 main methods:
- draw the pipes side by side and specify with a comment that they will actually be on top of each other
- draw a folio by pipe altimetry
- draw a single pipe and specify the number and characteristics of the pipes with a comment.
The method chosen depends on the complexity of the case: a hospital plan will go towards the first solution, etc...
Less frequent method, draw a single tube and make a "partial cut" representing the arrangement of the pipes.
Hello
If you are doing implatation rather than industrial design, I would say that it would be adapted with a more schematic document.
For example, you could put a normalized symbol corresponding to the height signals from the ground.