Hi all
I wanted to know if anyone knows how to change the font via a "part family" table?
You will find attached a word file
Thank you
police.docx
Hi all
I wanted to know if anyone knows how to change the font via a "part family" table?
You will find attached a word file
Thank you
You can't change it directly in word?
Go to the Solidworks options, and change the default font.
In fact, I would like the font to change automatically according to the selected family.
Change the font of an extrusion for example according to the configuration?
I don't think it's possible: you can't do it by simple configuration, so you can't find it in a family of parts.
The only solution is to multiply the extrusions (if that's what you want to do) and activate/deactivate them by the family of parts.
Hi @ nightmaire
Be careful in solidworks you will have much less font choices than in word
and the fonts between the 2 are not all compatible
@+ ;-)
The font is not part of the configurable settings... unless I'm mistaken,
You have to create several configurations for each font
then the configuration is more easily manageable
I can actually do several operations and activate or deactivate them depending on the selected part family.
On the other hand, I don't know how to activate or deactivate an operation with a family of parts?
When you're not sure how it's going to behave, give it a try:
_1 config with function enabled
_1 config with function disabled
Then go back to your room family. It will offer you to add a new column with the status of your function. This will show you a new column with NS and S values.
Edit with image
Thank you all