Hello everyone ,
I have a small problem on several holes made with the drilling assistant on SW2018.
I noticed when I was drawing my part that the thread was upside down (the selected edge is in the bottom of the hole and not at the inlet), and this, on several sizes of tapping holes (1/8 27 NPSM, or 3/8 24 UNF or 1/4 28 UNF).
I tried to reverse the direction with the double arrow, but that's not the problem because the software doesn't do the drilling because there is no material in the other direction. (see below)
Thank you in advance to all those who will enlighten me!