Hello, I have a very simple problem in a drawing of a large assembly, when I create my bill of materials I am missing parts in it so I checked that these parts were not excluded from the bill of materials in the parameters of it on my assembly and they are not. However, I can't seem to get them to appear in my nomenclature. Do you have a solution to force the appearance of a part in the nomenclature?
Are they separate parts and not mechanically welded bodies in the same room? Cra I've already had the problem with parts bodies but otherwise I don't see.
1 Like
yes they are separate rooms
Do you have any surface parts?
or parts imported in step
@+
1 Like
Are these parts in a subset?
Check the BOM settings vs. BOM parameter in the configuration properties.
4 Likes
Hello, I solved my problem by going through a tabulated bill of materials and I excluded myself the small parts that I didn't need or the parts that we buy already assembled.
a bit of work but that's because I wasn't the one who did the assembly. we still went from 240 pieces to 86 lol ... In my case, it was enough to enter each of my sub-assemblies and exclude the parts from the nomenclature since we bought the assembled part directly ^^ thank you again for your help.
1 Like
you just have to close the question
by checking solved my problem on the most adequate answer
This will allow other members with the same problem
to find the right answer just below the question
@+ have a good day ;-)
2 Likes