Problem with the Catia RDM module

Simulation Generality
1

Hello, I am currently working on a student project and I have to use the RDM module of Catia but I have a small problem during the simulation.


So first of all I place the embedding on the foot of the support and then the constraints in -Z which gives this:

Then I run the simulation and this is what it gives  me

 

 
But the problem is that in reality the top plate of the support does  not deform because it is attached to the part that imposes the stress. I don't know if it's very clear so I 'm also putting a screenshot of the system

. 

We see the support that carries the part in blue and it is this blue piece that imposes the -Z constraint

 

 

2

Hello

If you consider your top deck to be dimensionally stable, then you should put your stresses on the end of the mast and not on the top surface of the deck.

Kind regards

1 Like
3

ok thank you it solved my problem