Hello, for the first time I'm trying to put bolts on a frame screwed into a tube by two bolts.
Do you have to put a connection between the sets or not? In my case I tried both options.
When I create my bolts I enter the two edges and the diameter
During the simulation I have a flaw
Warning: Pre-load in at least one bolt connector is zero
Do you wish to continue?
I don't understand what to do.
On the other hand, should I enter prestressed or not?
Thank you for your help
Is it possible to have a screenshot of the board with the holes of the connector that is causing problems?
Hello
To put imposed bolt-type movements, you first need to create a virtual wall. When creating the imposed displacement, you will only have to select the contact edge of the bolt and the virtual wall.
Personally, I only put one bolt at a time.
Hoping to have answered your question.
Cdt, Hugo
On the other hand I create a virtual wall or?
I was able to move forward I think
I made a contact between sets of the no penetration type.
I can do the simulation
The results are attached.
What do you think? Is it good