Hello
I created a drawing with an exploded view of a piece of equipment.
I then inserted a nomenclature.
When I add automatic bubbles (in manual, it's the same), the numbers are good but the arrows don't point to the pieces, they are offset.
If I move the arrows on each part, the number changes and points to the wrong one in the nomenclature...
On the other hand, on a "non-exploded" view, everything is OK.
There you go, if anyone has an idea...
Thank you
In the view properties, you have to check the box "link the balloon text to the specified table", see PJ
Hello
check see also you are up to date with the version of Solidwoks (sp4 for 2016 and 5 for previous versions) it may be a small bug that has been fixed.. 9:10 a.m.
Hello
No better than @stefbeno, you have to activate the function in the properties of the drawing.
Hello
Thank you for this information.
I'm in SP3 so update SP4...
Then, the "link balloon text to the specified table" checkbox is checked
In fact, it is not a connection problem, but a problem where the arrows do not point to the parts and are offset, see attached pdf
Thank you
Hello
I have the impression that you are in perspective view (with vanishing points) on the drawing. I had the same problem, apparently Solidworks hangs the arrows where the parts should be in normal view (without leak points). I'm in 2012 version and I don't know if this bug has been fixed in the more recent versions.
Try it out by removing the perspective mode (with vanishing points) from your view.
Does reconstructing the exploded view or selecting either the brackets by the faces or by the edges help matters?
Otherwise as @ac 427 cobra says, it may be a bug related to 2016, an update may fix it:)
SP4 update, nothing has changed...
On the other hand, if I explode my assembly in the iso view, then it's good.
My 2 exploded views were positioned according to personal angles and it must have bothered SW...
Weird...
So I have another question:
Automatic bubbles do affect the correct part numbers, but if I delete some and put them back in manual, I get a star * instead of the number....
A little idea???
Thank you
Have you selected the right property related to the balloon (see balloon text)?
Yes it's on "article number", like the others...
On the other hand, when I hover the mouse over the tooltip, it is marked that this component is excluded from the nomenclature...
It's okay.
Some components were marked "excluded from BOM" in the part.
Everything is back to normal...
Thank you all
Pb solved
Thank you