Hello everyone,
I have a dimension that doesn't want to fade (I had made a sketch with dots by erasing them the dimension remained) see capture
Thank you
cote.jpg
Hello everyone,
I have a dimension that doesn't want to fade (I had made a sketch with dots by erasing them the dimension remained) see capture
Thank you
A green light doesn't solve the problem?
Hello
A CTRL+Q doesn't delete it?
Hello
A two-tone or CTRL-Q shot doesn't work??? Are you under 2017??? If so, there are some rating bugs with the sp1 and 2...
No, a green light shot didn't work, it's in an assembly and it evolved a number of times, I don't even know in which sketch it was. The name of the RD1 rating
I'm on SW2016 sp4, crtl+q nothing to do
Can you select this said rating?
And if you right-click on it, you can edit it to delete it???
I used to hide the reminder and dimension lines, at least visually it "shocks" less in front of the customer
I can section it but I haven't deleted it in the menu,
Thank you for the answers and for the time you have given me
:)
This dimension must come from a part of your assembly
so if you can select this said rating
you should know in room it is
So open this said room
and suppresses this said rating
@+
Hello
If it's for a presentation, you can hide the top-level annotations, and normally this call number should disappear. It's from the drop-down pane of the eye-en-eye icon.
Hello, the solution is in the visibility control (the eye).
The small arrow to the right of the eye allows you to preselect the D1 logo that corresponds to the names of the dimensions.
Hello @kryen
Thank you for your contribution, but I would like to draw your kind attention to the fact that this is a topic of 2017.
So it's a digging up ;-) ;-)
Kind regards