Unfortunately it doesn't give much hihi.
I need to enter these values in a table but when I do, it doesn't work (I always use a 1mm radius when I draw to simplify the thing).
At worst, I will ask my boss for a day of sheet metal training.
:-)
If it's just to change the K factor according to the thickness, I may have a solution that could work.
If you are under 2014, there is a new function that allows you to set the K factor according to a configuration.
All you have to do is create a document template with the different configurations (ep = 1 ep = 2 etc....)
And to link the K factor to the thickness. (See image) same for the bending radius.
To try. =)
Thank you Bart, I'll try your solution. She seems not bad to me at all^^
Watch this tutorial video
https://www.youtube.com/watch?feature=player_embedded&v=d068bXXRsU8
@+ ;-))