Problem drawing a sheet metal part under SW

2D plans Layout
1

Hi all

I have a small problem with the layout of a sheet metal piece. Usually, when I put my unfolded part in the unfolded drawing, it remains well unfolded, even when we work on the 3D again.

Currently, as soon as I touch my 3D, my part goes back to the folded state.

What to do?

Thank you all.

2

I found the solution by looking at the question asked later via the following link:

http://www.lynkoa.com/forum/3d/mise-en-plan-d-une-piece-pliee-solidworks

Bart had answered the question. So thank you Bart.

Have a nice day

2 Likes
3

Sorry it's been 2 times that I've asked a question and I've answered it right away. I promise next time I'll look properly before asking my question.

Have a nice day.

3 Likes
4

I have this problem from time to time, personally when it does this to me I delete the "flatpentern" configs (to do this you have to quit the drawing first) 

then I do a unfolded state, sometimes it works... otherwise I recreate the part or the function... (I'm tinkering with what^^)

1 Like
5

Hello

 

It also happens to me sometimes. Look in your configurations. Maybe you work in the unfolded or else send me the part and the drawing.

1 Like