Problem opening a file on edrawings

Out of category
,
1

Hello

I have a small problem with the edrawings 2020 software. A little explanation: I design the parts on SW 2020 and then these parts are taken back to be machined by our workshop. In order for them to be able to view my parts in 3D format, I installed edrawings 2020 VIEWER on their pc. And today we noticed a problem. The opening of a piece on edrawings is not up to date (see the images). This error message appears: The displayed file is outdated.

The geometry of this part depends on another part, therefore, I have been researched the parameters of the external references but without success...

Have you ever had this problem?

What solution?

Thanks in advance


piece.pdf
2

Yes, the preview in edrawing is graphic. That is to say that the 3D preview is created at the time of recording the part.

The problem is that when you create your modifications from an assembly, the graphic data is regenerated only in the assembly and not in the room, hence the message.

And we had asked the hotline, the only solution is to open the part and re-save it to update the preview in edrawing.

 

3 Likes
3

Thank you very much for your answer!  @sbadenis