Hello
I'm facing a pb. I made a smoothing (surface) with several sections and several guide curves.
Only in the middle, my surface does not go through my sketch (section) but only over an area.
Has anyone ever encountered this pb?
Thank you in advance.
Hello
It would be possible to have access to this part (if for example you remove everything and leave the sketches and smoothing out)
Because without the file, it won't be easy to find a solution
Mick
Hello
Have you verified that it is not simply a display quality problem. To find out, we can try to select the edge of the surface. If it's just a display problem, the edge will be highlighted where the sketch is and not by following the surface.
I checked that it was not a graphic problem and have a gap in a mep between my sketch and my profile.
@mcordero, sorry, but that's not going to be possible. It is a very sensitive subject and above all very confidential (Chernobyl).
I can't stream 3d. Only views (but very localized)
If you can't spread more information, you should contact your dealer's hotline who can take control remotely and better target the problem.
Well, I can't contact my dealer (axemble), it would be too long...
I'll try to give you as much information as possible:
It is a surface smoothing consisting of 15 sketches for the sections and 4 sketches as guide curves. Over the entire surface, the smoothing follows the 4 guide curves well. It also passes for all sections only on one of them, there is a defect and at one end of the section, the surface does not conform to the section sketch.
I hope I have been more explicit to make it easier for you...
I think so, but you might as well make sure, does your guide curve have a meeting point with your section?
Otherwise, have you tried to use the surface border function rather than surface smoothing, the result may be different?
Mick
Sorry for this silly question, but sometimes you have to ask some: at this precise point of the problem, the guide curve and the section sketch are really coincidence? There is not a slight shift, a point that would be hung in the wrong place,... Before smoothing, the sketches are well "connected"?
Another thing, could you make us a print-screen of the Feature Manager of the smoothing function? Just to possibly detect an option to tick.
Then....
Here is attached a view of the tree.
Yes, I checked, the guide curves go through all the sections.
I tried the mcordero solution (boundary surface) and it only works it lags a lot. But good to see, I now have to rebuild everything behind it!