Hello everyone,
I sometimes have a problem when I put a material to my part, I have a yellow triangle indicating that there is a problem → yet I put a material from the Solidworks library. Do you know why?
Hello
What a version of SW.
Is it a file from a step or another with an imported solid?
1 Like
Hello;
Most of the time it's because there's a conflict between the " forced " mass and the mass calculated with the material...
Check that " replace ground " is not checked in " ground property":
If this is the case, uncheck the cell and then reassign the material so that you don't have the error again.
(this happens very often on imported components such as WWTP or parasolid...)
Kind regards.
7 Likes
I'm in 2021, and yes it happens to me most often when it's an imported
I can't find this option, I'm on Solidworks 2021, is it possible that it's elsewhere?
Hello
I also often have this problem.
Thanks to @Maclane for the tip, I'll test it when the time comes...
The adjustment is here:
3 Likes
Thank you very much, and yes it solves the problem 
1 Like