fouch
October 6, 2014, 3:19pm
1
Hello
Sorry, I don't have the full error message but this message appeared when opening a basemap I created.
The size of the basemap is standard and A2 format. A smaller frame surrounds the background, the background 10 minutes from the edge of the A2 format
I hope you have enough information.
Friendly
Philippe
pl
October 6, 2014, 3:22pm
2
Hello
Specifying the software could also help because since the update of the site, not all the tags appear!
=> "3D, CAD, Import / Export forma ... "
1 Like
bart
October 6, 2014, 3:47pm
3
Hello
I think it doesn't come from the software, but from the print settings.
You will need to adjust the print margins of your printer or plotter.
Keep us informed!
And specify the software too =)
2 Likes
Good evening
Apparently you work on SolidWorks, so here's what might come close to your message:
Wouldn't you have done a shot with a cut? And in this case, you may have made a partial cut (cut line not overflowing or no longer on either side of the view). If so, right-click on the section view, edit the sketch or pull directly on the crop mark to make it overflow.
1 Like
bart
October 6, 2014, 9:01pm
5
I thought about it Benoit, but why this message?
2 Likes
gt22
October 6, 2014, 9:12pm
6
You can post the error message I have a friend who collects it
and this one he doesn't have
Thank you
@+-))
3 Likes
pl
October 7, 2014, 9:24am
7
Hello
A priori, it is the margins of the printer that are larger than those of the drawing settings.
Just correct the margins:
http://help.solidworks.com/2011/french/SolidWorks/sldworks/LegacyHelp/Sldworks/Fundamentals/HIDD_PRINT_MARGINS.htm
In your case, you have to use the printer's margins (so check the box).