Which 3D printer to choose?

Other sections CAM
21

I don't recommend the Da Vinci. Apart from the fact that I didn't get very good feedback, the cartridges are proprietary (between 35 and 50 € for 600 g). 

22

@Gerald: I have seen this printer but it is not stereo lithography! And in addition I read that it is a proprietary filament so to be avoided!

23

@bart: I couldn't find a kit for Ultimaker for less than 800 euros.

And you say that the printrbot is expensive while the models are $400,500. Is the impression so bad?

24

Yop .PL. I do a little determent... I was watching videos of deliriums on 3D printing (yes well, we keep ourselves busy as best we can). And now, I see two printers linked so I thought of you without knowing where you are in your quest or what they are worth

 

One at 400€: http://www.reprap-france.com/produit/1234568322-imprimante-3d-micro-delta-revision-1-1

One at 750€: http://www.reprap-france.com/produit/413-imprimante-3d-de-bureau-up-mini

 

But they seem to be having a good time with it

 

Otherwise, if you have time to kill, the not very intelligent video that made me laugh: https://www.youtube.com/watch?v=JUc8HBtlxUc

25

Hello

I just discovered the DAGOMA model at 299€ and made in France:

http://www.dagoma.fr/categorie-produit/imprimantes-3d/

Which has very good feedback:

http://www.lesimprimantes3d.fr/test-dagoma-discovery-200-20150829/

http://velocirepraptor.com/test-discovery200-limprimante-3d-a-300e-en-kit/

Do you know? Do you have an opinion on this model?

 

26

If anyone is motivated to do a comparison of all the printers... :)

If not, I will.

27

Finally, in my opinion, the best model is the DAGOMA Discovery 200 for:

- its price 299€ in kit and 399€ assembled

- its print volume of 20 cm x 20 cm x 20 cm

- its French conception (let's be a little chauvinistic!)

- its accuracy to 10 microns

Thank you all for your advice!

Link to the website:

http://www.dagoma.fr/produit/le-kit-discovery200/

You can even find people nearby to get their feedback and see the printer in action.

A priori it is better to take the build tak board with:

http://www.dagoma.fr/produit/build-tak-special-edition/