Setting Units for Ground/Volume Properties

3D Design Volume Model
1

Hello

I would like to have in each part and assembly in unit mass the KG and volume the M3 but impossible to put it by default. Is there a solution?

I know how to change every time but I can't keep the configuration.

Thank you for your help.

2

Hello

You have to save them by default in your models. Create a dummy room and set and save your room in . PRTDOT and the same for the assembly in . ASMDOT and there your settings will be kept.

4 Likes
3

Hello

Thank you I have been able to move forward since then thanks to this answer, but the time to answer.

It's a good sign, there's a lot of work to be done!

Thanks again

1 Like