Hi all
I blocked on the repetition of a bodyguards of a spiral staircase. Here is where I am.
thank you for your feedback
thank you for your feedback
Hello @Rems51
In order for us to help you, we would have to confirm that it's only " Hélice /Spirale 3 " that is causing you trouble.
What we can see is that the step of this spiral does not have the right step and is not in the right direction (clockwise spiral for the outside and counterclockwise for " spiral 3 ")
Post your ASM with a pack and go so that the experts in unveiling can say a little more.
Kind regards
1 Like
Hello
Rather than using the spiral, I personally used the edge of the shape from scan 1 and then selected the face of this scan in the " Normal to face " option.
Result:
I am not making the file available because I am on SW2023 and the file is in another version.
3 Likes
THANK YOU
And for this type of GDC do you have a solution?
GDC-NON-LINEAR-MODEL-TEST. SLDPRT (193.7 KB)
Thanks in advance
I must not have the right file, but I think that by making a composite curve, by recovering the outline of the lower part and relying on the external face to give the orientation, it should work.
Hello
The problem is that there is a change in the orientation of the plane, so apart from doing it in several times I don't see a solution to do it in one operation
1 Like
That's the problem 
Check this out, it might help: https://www.youtube.com/watch?v=Fi_CLPtObWw&list=PLjkvI_IbLbweeJrlJR_KmjB0g8EOoESkg&index=34