Hi all
I want to make a repetition of a sketch (a square) following a spilne curve and I need your help (photo attached)
thank you in advance
spline.jpg
spline.jpg
Hello
If you want to extrude directly, position your spline on a corner and not in the center (it's not like on other Inventor software for example)
Moreover, if your spline is on the same plane, that's enough.
If you want to have several squares you need to make as many spaced planes as you want. And for each square on each plane make a coincidence between the corner of the square and the spline.
If it's a three-D spline then you need to put several guide splines in addition if you want to avoid surprises.
1 Like
You can create your room via a swipe
To do this, you need to create a perpendicular plane
to the right of the start of your spline
and make your square section on this plane
Be careful to watch out for the handlebars (bending radius) so that it is not less than 3 thicknesses of your section
10 square 30 radius
@+
2 Likes
Something like that?
Sorry @PhilippeB, my answer came too late.
Indeed a repetition driven by a curve
1 Like