I can't display the thread representation I want.
Either the line starts too late, or the line ends too soon.
It seems to me that it worked very well before my last update. What could be my problem?
Hello
Which version of SW?
What are the conditions for the start and end of threading in 3D?
I think there is a typo, in view of the screenshots of the interface it is rather the 2022.
Unless I'm mistaken, for the first view it's the selection of the edge that must be the problem, it's probably the edge of the chamfer background that has been selected.
For the second method, it is the condition of the one-eyed end that probably poses a problem.
If you can share the model, it would be easier to find ourselves in the same conditions to help.
In general it's better to set the thread representation before the chamfers, it goes better overall from memory even if I prefer a thread drilling function than adding a thread representation after the fact.
2 Likes
This is the 2022 version.
It's solved!
What I don't like is having to go through the one-eyed mode for the 1st time to access " start from a " to give the starting point.
Thank you for your help.
Probably a bug in the 2022 (not the first one I would tend to say).
If I'm not mistaken, this interface is related to the deployment of the 2022. Foot coded
1 Like