Hello
A very simple question.
Which symbol should be used for bent wire assemblies (diameter 5mm)?
I feel like I'm only seeing symbols for flat surfaces
In my GDI, I don't see the case of the bent wire.
Thank you
a small wiki
http://fr.wikibooks.org/wiki/Soudage/Conception_d%27un_assemblage_soud%C3%A9
1 Like
Hello
I think there is no specific symbol, an annotation on the plan will be enough in this case.
2 Likes
There is nothing special about it. We must use the conventional rules found in the GDI or AFNOR. On the symbolic writing, the type of welding (111,...) can be specified
2 Likes
Hello everyone,
What do you call bent wire welding? like TIG? or solder?
I think you mean n)8 of the attached drawing.
for you it would not be 111 but 113 (bare wire welding or 141 for the TIG
There you go, I hope I was able to help you
PM
img23.jpg
Thank you for your contributions, what symbol would you use to rate this weld?
V, half-V, others?
Thank you
snc14724.jpg
Since we don't prepare the two parts, I'll put normal fillet welding.
the V or half V designates the preparation of the parts before welding. Now we have nothing to do, they are round.
Do you know what I mean?
2 Likes
Like "PMF", at one or two customers, this is what we do: basic fillet welding with just the indication of the size of the bead.
It is also necessary to see if the manufacturing is done in-house or subcontracted, and if so if the subcontractor is known. And possibly get closer to the people who will make the piece.
2 Likes