Hello
I can't reverse the bending angle on the tôle.je can't pass it beyond 90° to get the part represented by the lines. See attached file
Thank you for your help
tole_bouchage_cheminee.sldprt
Hello
I can't reverse the bending angle on the tôle.je can't pass it beyond 90° to get the part represented by the lines. See attached file
Thank you for your help
Hello
The goal of the manipulation is to have the piece represented by the lines?
If this is the case, you might as well draw it immediately in sheet metal or in volume converted into sheet metal.
If not, I understand the problem.
Yes, that's right. I tried the 2 solutions from a boss converted into a fold and sheet metal with transition folds...
Change your folding position options, they must not be tangent
Hello
Can you post the part in step I am in 2017.
EDIT/but normally if you double click on the pink arrow the fold changes to the side of the other side just in case!.
may the force be with you.
Hello
Starting from your step I have no problem.
Here is the 2017 SW coin
may the force be with you.
Hello
Choosing "external virtual intersection" instead of "tangent fold", in the length area of the folded sheet, would perhaps solve the problem?