Hello
I want to make a mesh of a pipe, but I get errors on the library elbows. I think that a mesh cannot be made on configurations other than the default configuration. What do you think?
Thank you for your feedback.
Hello remi.bression,
I'm not a mesh expert, but I can get it by only " Simulation Xpress Study ", it works that I have a part not an assembly, see attached image=>
In another way, I don't know how to do it. (SW2022. SP4 " Standard ")
Additional information: =>
SimulationExtrait.pdf (674.9 KB)
and
Assembly1.SLDPRT (81.2 KB)
Item1.SLDPRT (59.7 KB)
Assembly1.STEP (17.5 KB)
Keep us informed, @+.
AR.
Hello
1st question shell or volume mesh?
2nd question: if it's imported from the store, check the geometry (in particular the material extrusions to mark a " bene inox " type logo) because this kind of logo quickly weighs down a mesh
2 Likes