Hello
I can't seem to do the simulation of my structure (it's to be able to make a calculation note) under SW. Every time it sends me this message about interference
Thank you in advance for your answers.
Jeremie
capture.jpg
capture.jpg
Hello
Try to see in this way; It should work:
http://www.lynkoa.com/contenu/créer-une-pièce-partir-dun-assemblage-pour-facilter-les-simulations
3 Likes
Indeed, solidworks does not accept interference in the calculation. 2 solutions:
1 - Remove interference and add the appropriate contacts
2 - Turn your assembly into a part and then merge your bodies to remove interference
3 Likes
You have interference (i.e. overlapping matter).
Open your assembly (or open your part in an assembly) you go to "Evaluate" then "Interference detection".
You run the calculation, you look at what are the interference areas and you manage to remove them.
1 Like
Hello
I tested your methods, and it didn't work. In fact I have a lot of my constraints that are badly done (red) which explains the overlapping of materials, I think that's the reason why it doesn't work.
Thank you again for your help.