Hello everyone, I don't know if this question has already been asked, but here it is, on the computer I use at my workplace, I had to install SW 2020 SP5, I was previously on SW 2016, when I created a DXF file with Autocad (flat conversion of a part in sheet metal to be able to make a cut with a jet cut of water), I went straight to the drawing of this same room by pressing a keyboard shortcut (D key, I don't know if it's basic on the software, or if it's a shortcut already established by my employer, in any case, I've never touched it). But here's the thing, on the 2020, it doesn't do it anymore, even when I do the Create a drawing function, it doesn't work. I have to open another room from the Open function , and then come back to the room in question to do the drawing.
If anyone has any answer to my problem, thank you, it would save me a lot of time and avoid all these manipulations.