SW: Inconsistent Weld Parts List

3D Design Volume Model
1

Hi all

Today I would like to ask a question about a problem that happens to me from time to time.

By taking over welded mechanical assemblies from one of my predecessors, or even sometimes mine, I can't display suitable nomenclatures.

The lengths are absent, while the profile is well set up as always...

sometimes it gives me a quantity of 2, and another line with 2x again, for a profile present only once ...

- my assemblies are not merged

- My welded parts list has already been updated before drawing.

In the attached example, you can see a welded mechanical body (aviary), designed as usual, and yet the nomenclature does not come out correctly.
I'll also try to add another screenshot example to be more explicit.

Thank you in advance for your help.Structure Volière

2

Hello

Does deleting and then reinserting the table change anything?

If there have been changes in the 3D, sometimes it is necessary.

3

I tried several times to delete the table and replace it, while updating the list of soldered parts, but nothing helped.

4

And update the parts list and then rebuild everything with CTRL+Q in the 3D then in the 2D and finally reinsert the table?

5

Hello.

My reflection is probably stupid, and maybe you have already checked it.

But when you're in 3D and you're going to study the list, does it correspond to your desire? (if you go to the 1st set, does it highlight all the rooms dedicated to it)

And by clicking must property, are the values left in automatic or have they been forced by hand?

6

@ PL: I've already tried all this several times without result.

@ Coin37coin: by doing this process, it didn't change anything, BUT, I realized that the famous profile group, which is problematic for the nomenclature, are written in English, see attached. 
Basically everything I did myself comes out well, and the old parts no longer give a side in the table. ...

Precision: I redid this simple structure, starting from scratch, and all the dimensions come out easily if I create each part myself.


exemple_arbre.png
7

Hello 

This problem happens to me from time to time, it can help to do in the room:

- right-click on the list of welded parts

- uncheck "create auto-list" and "auto-update"

- right click again and "delete"

Then 
- right click on the list of welded parts and tick "create an automatic list of welded parts"

 

2 Likes
8

It should help the @be thing a lot

 

And if it still doesn't work, I'm afraid you'll have to enter the properties of the list manually and reassign the right variables to it correctly

9

Thank you BE,

This answer helped me on this one.

In fact I have to make some clarifications, I don't know if it's because I'm still under 2013 for the moment. but I had to do it like this:

- right click on list of welded parts: uncheck automatically (nothing else to uncheck)

- right click on the list of welded parts: click on "remove"

- right click on the list of welded parts: click on "automatic" again

- Right-click on List of welded parts: click on "Update".

At this point, a loading of several seconds, followed by corrections to the table of welded lists. So thank you this technique works.

I'm going to try the same thing on the other lists or I spotted this problem, because I had temporarily added the information as "manual notes".

So I may come back to you if it doesn't work for the other problem I encounter^^

Thanks again