Special symmetry!

3D Design
1

Hello,
I would like to make a special symmetry!
Below is a view of a symmetry that I qualify as normal

image
image409×689 19.7 KB

and below the symmetry I would like to obtain
image

Is it possible?
Thank you for your help
Fred
Symmetry test piece. SLDPRT (67.2 KB)
Assembly, test, symmetry. SLDASM (71.8 KB)

2

Hello Frédéric_ALLEAUME,
I found this solution=>See attached file
Trial assembly symétrie_AR. SLDASM (108.8 KB)

Well, apart from going through a configuration of your part or another symmetry of your part in your assembly, I can't find any other solution

Well here is your part configured=>
Symmetry Test PartConfigured.SLDPRT (73.5 KB)

Good luck.
@+.
AR.

1 Like
3

Not possible via symmetry (since it is not a simple symmetry.)
Only symmetry solution, then body displacement (rotation and possible X/Y displacement)

2 Likes
4

As said @sbadenis it's not a symmetry.

The good news is that it's a circular rehearsal.

As the repetition does not freeze the center point, you can put 2 dimensions between your pieces to fix the second as you want.

1 Like
5

@froussel Symmetry + Rotation for me!

1 Like
6

@sbadenis " It's not wrong " as some would say...

7

Hello @A_R
I'm in SW2020 I can't open your files.
Fred

8

Oh dear!!
Because if I go through a step, it won't be good for you.
But hey, the manipe is not complicated.

  1. Or we go through symmetry and rotation as mentioned by colleagues.
    2) Or make a configuration of the room.
    @+.
    AR.
1 Like