pl
March 30, 2015, 12:15pm
1
Hello
On the attached file in SW 2014, I have a problem with the drilling table. It is an old room that has been slightly modified.
For F & G markings that are indeed taps, there are not the same options as for A or B marks.
We only have access to the tolerance, but we can't display the M12 size.
Do you have the same problem?
I tried to put the dimension on the view via "symbol for drilling" and it gives me the following error message:
The dimension then corresponds to what is in your table...
Do you have the same message?
coyote
March 30, 2015, 12:58pm
4
Hello
Same thing in 2014 and 2015 the only difference I see is the fact that the F and G is through everything
@+
remrem
March 30, 2015, 1:15pm
5
The same result as @Coyote.
For the F's, the "Through everything" remains even if I change the ending method.
pl
March 31, 2015, 8:41am
6
Thank you for directing me, it was a configuration problem (two versions of SolidWorks installed and badly uninstalled). I reset the settings to default, and it worked.